After many attenpts the lift Wing printed. Only one Wing to go. For soze comparison I included a Wizard.
It‘s 87% of the orogonal size, because it wouldnt fit on my MP Select Mini in 100%. And even in 87% it was quite difficult to place the Wongs on the printbed.
Also, I hat supports. I needed quite a few of them. But it printed. Tomorrow #Tiamat will be ready to be painted.
Then the Characters need to go through the whole Tyranny of Dragons until she will be on the table. But it will be glorious! #3DPrinting #Monoprise #DnD #TyrannyofDragons #RiseofTiamat #dnd5e