Which is a bit scary for "oh, I'll just close those slots to protect them from garbage". Still not sure if it works afterwards (it does switch on; when the power is back, I'll print four more inserts for the back sides of the same extrusions).
Cable management is precarious if you barely have any space behind the printer as I do. In the back position the bed cable wants to loop behind the ribbon cable of #CrealitySprite , and that one is rigid and isn't easy to slide against 🤷🏼‍♂️😬 #3dPrinting

The first part of cable management for #CrealitySprite. Unfortunately the second part got power outage early in printing, and in recent versions of Marlin it never resumes correctly. This one cracked while putting it on 😬 At least new #treeSupports in #Cura are looking cute, if in need of tuning from my side.
#3dPrinting

Printed a cute tablet #weaving (well, you can do any weaving narrow enough) shuttle and tested filament change with my new #CrealitySprite hotend/extruder setup. Glad I did! Max x was set to a number it couldn't possibly move to, that caused the colours to be misaligned by some 6mm or more. Thought of cutting the extra off but realized it would be rough and unusable, so printed again. If you put Sprite on regular Ender 3, check this! Went from 248 to 230. #3dPrinting