GuruHiTech · @guruhitech
127 followers · 1332 posts · Server mastodon.uno
Rafael Roa · @rafaelroa
73 followers · 10 posts · Server malaga.social

Imprimiendo un catálogo de colores para referencia rápida 😉

#impresion3d #3dprint #ender #ender3s1

Last updated 1 year ago

Sergio Bruder · @sdbruder
44 followers · 173 posts · Server mas.to

@3DPrinting how meta printing the case for the new printer screen

#klipper #ender3s1

Last updated 2 years ago

Sergio Bruder · @sdbruder
42 followers · 172 posts · Server mas.to

@3DPrinting Still trying to fix this bed mesh, It looks like I an issue in some of X axis wheels?

#bedmesh #klipper #ender3s1

Last updated 2 years ago

Mat (notenoughtech) · @notenoughtech
79 followers · 110 posts · Server mastodon.world

Inexpensive printers can be difficult to setup and tune in, but was the easiest one to get started with. Easy to assemble, brilliant print quality straight from the box, great features like BLTouch and DD extrusion. Full review here
net_r
notenoughtech.com/3dprinters/c

#ender3s1 #3dprinter

Last updated 2 years ago

Sergio Bruder · @sdbruder
41 followers · 137 posts · Server mas.to

@3dprinting Tuning bed leveling and first layer. After `SCREWS_TILT_CALCULATE` multiple times to get the bed with "zero" tilt, measured Z distance and re-did bed mesh, I've got this, not perfect but getting there. Octogon got still some areas of defect but most of it is good. Perhaps I should give my bed mesh more probe points?

#klipper #ender3s1

Last updated 2 years ago

Sergio Bruder · @sdbruder
41 followers · 137 posts · Server mas.to

@3dprinting Switched recently my ender3 S1 to klipper, got some great initial prints and started to fine tune it, now I think I’m printing too far away from the bed: already got 2 failed prints, doing something clearly wrong. Someone can point me how to properly level the bed, “paper test” it’s distance, save the bed mesh and how to properly retrieve it in the start code with klipper?

#newbie #ender3s1 #bltouch #bedleveling #klipper

Last updated 2 years ago

Sergio Bruder · @sdbruder
34 followers · 102 posts · Server mas.to

Found them. Past me was smarter: it was, mind you, in my box of hex screws.
And they were rather easy to find: they were in the bigger nuts left small box and they are metal while everything else on my box is black. DUH. Like I said, past me is smarter than me.

#stupidme #ender3s1

Last updated 2 years ago

Sergio Bruder · @sdbruder
34 followers · 102 posts · Server mas.to

Stupid me opened the bottom plate of my ender 3 S1 literally months ago. Now that I finally decided to close it, of course, lost all screws. If you have a ender3 S1 can you measure your screws fixing the bottom plate?

#stupidme #ender3s1

Last updated 2 years ago

DanFell · @DanFell
62 followers · 384 posts · Server mas.to

props for the kids holiday play with PETG, .16 resolution at 200 mm/s.

#ender3s1 #3dprinting

Last updated 2 years ago