Let’s play #GuessThatPrint!

This is a test fit, so it won’t end up this colour. Also, this is nearly maxing out the #Ender5Plus in one axis for scale.

#3dPrinting

This afternoon I shall be configuring my #Ender5Plus and running a test print now that the #BigTreeTech #SKR2 board is installed and wired up correctly.

This morning I installed @octoprint on my Pi Zero 2 W and got it talking to the #Ender5Plus and Cura on my Mac Studio. Ran out of time to configure the filament extrusion speed because…

This afternoon I’m off to see #DungeonsAndDragons in Fulham because I saw a hilarious trailer which hooked me in at Chris Pine playing the lute.

@gulfie @octoprint Good job!
At some point I'll get back to my own #Ender5Plus as well, finally figure out what's up with the damn heated bed.

I’ve at last found some time to troubleshoot the #BigTreeTech SKR 2 I installed into the #Creality #Ender5Plus at Christmas.

I removed all the cables and then reconnected them one at a time, turning the power on afterwards and waiting to see what happened.

Everything worked fine, until I got to the last thing to connect, the BLTouch module. As soon as the three-wire connector was plugged in, the board started shutting down again.

Sharing some printer farm pics #3dprinting #raspberrypi #octoprint #prusa #creality #ender5plus #canofbeans

Skull chalice

#3dprints #hex3d #Elegoo #ender5plus

Mcknuckleduster
#3dprints #hex3d #Elegoo #ender5plus

Close to maxing out my #ender5plus print bed. Doesn’t happen often but nice to have the option. #3dPrinting