Going to try relocating the PSU of my Neptune 2S 3D printer from its vertical position to below the print bed. Printed four feet that are needed to raise it yesterday, now printing the mounts which will be 2 10 hour prints. Hopefully everything goes well!

Most of my prints have been printer-related parts lately 🤔

#neptune2s #3dprinting

Printed this PSU silencer for my Neptune 2S 3D printer and it reduced the sound it makes quite a bit!

I was worried about the PSU temperature rising at first, but then remembered that when my PSU fan died I didn't notice until many hours of printing later :blobcatgrimacing: So I hope it won't die because of some air restriction...

https://www.printables.com/model/84197-60mm-exhaust-fan-silencer-flowmaster-psu-ender3nep

#3dprinting #neptune2s #elegooneptune

I was so satisfied, seeing the little wheel spinning as the filament went in and out of the run-out sensor. #3dprinting #elegoo #Neptune2S

The 3D printed filament guide for #elegoo #Neptune2S is in place. No more squeak in the run-out sensor on retraction! The 608RS bearing was a very tight press in there. Now onto an 11 hour print, making a stand for my mug on the Keurig at work that I designed myself in #AutodeskFusion360. #3Dprinting