WIP of one of my ultra popular #ledmask the Anubis ! 783 x #apa102 5050 pixels on 144ppm 10mm strip driven by an #esp32 using my very latest animation system & the latest interactive, appless #webapp to set up the animation que. Using the global brightness system, specialy utilised on the APA102 & #sk9822 chipsets, Im able to drive this from a standard 15w USBC powerbank. Most of the super bussy animations are dimmed (using GBB) whilst still giving a full blast experience.

Turn Your Furniture into a Light Show with Hyelicht https://hackaday.com/2022/11/26/turn-your-furniture-into-a-light-show-with-hyelicht/ #addressableleds #touchscreen #philipshue #homehacks #LEDHacks #sk9822 #ikea

Turn Your Furniture into a Light Show with Hyelicht - There’s something about the regimented square shapes of the IKEA Kallax shelf that... - https://hackaday.com/2022/11/26/turn-your-furniture-into-a-light-show-with-hyelicht/ #addressableleds #touchscreen #philipshue #homehacks #ledhacks #sk9822 #ikea

Almost done with this #ledmask I need to add some blackout tape around the eyes, as there is way too much light seeping inside. Feels like a disco on my face #sk9822 #apa102 #esp8266

Almost done with this #ledmask I need to add some blackout tape around the eyes, as there is way too much light seeping inside. Feels like a disco on my face #sk9822 #apa102 #esp8266

Almost done with this #ledmask I need to add some blackout tape around the eyes, as there is way too much light seeping inside. Feels like a disco on my face #sk9822 #apa102 #esp8266

WIP: I have secured the matrix to the rear of the mask so the pixels backlight the forward wall. Have attached the headband with buckle straps & connected the controller to the headband. This has 216 x #sk9822 #apa102 pixels driven by the @espressif_systems_official #esp8266 I was a bit over eager on the pixel count, had to do some trimming & adjusting around the upper edges of the matrix. Next up, a soft piece of fabric for the back, neaten up the cables & set up my favourite que #ledmask

Pixels pixels & moar pixels! Slowly getting the backing matrix assembled. All the strips are soldered from the rear to save cable foldimg space around the edges of the mask. Using #sk9822 #apa102 5050 #ledstrip #pixels #ledmask #esp8266

This is my 3rd attempt at modelimg a mask in #fusion360 using #surface modeling. Took about 10 hours to print,its hollow with a 5mm air gap between the rear and front 1mm walls. Fits perfectly and is about to get all lit up! Ill be using #sk9822 #apa102 5050 pixels on 10mm wide 144ppm strip for the highest pixel count i can get on the inner surface