@koz

I think it is all due to the "Stae of #opensource in #3dprinting" by Josef #Prusa that led to this.

We have 3 routes we can take now. #Closedsource #Bambu printers, semi-open #Creality (which is just a copy of everything out their basically), and #Opensource #Voron.

I am disappointed in Creality just becoming copy-cats and also releasing stupid stuff like the Creality #SonicPad and locking it up as much as the #FLSun 400 controller.

But companies like #AnyCubic aren't even trying to copy #Prusa. They are just cntrl+f'ing them by now.

@3dprinting #3dprinting

Protipp: Man kann sich für seinen #3D #Drucker ein #SonicPad für 180€ kaufen um #Klipper zu nutzen oder, wenn man geizig ist, einen RaspberryPi und ein altes Handy aus dem Bestand nehmen. Ich habe mich für zweites entschieden. Läuft... Ach ja, das Teil steht auf der WaMa im Bad. Schleudern und Drucken gleichzeitig geht nicht. 🤪 PS, bis 150mm/s geht. Drüber braucht man nen zusätzlichen Lüfter und es sieht nicht mehr so sauber aus. Pressure Advance justiert. Ringing ist unkritisch.

Fun fact and tip!

If you are new to #Klipper, #Creality released their source for the #SonicPad. So you can find a good printer.cfg file to get started with!

https://github.com/e-dreyer/Creality_Sonic_Pad

@3dprinting #3dprinting

@geekandi@tooting

Although #3dprinters such as the #Creality #Ender3 and #CR6SE are #opensource, it is only due to the lisencing of the #firmware such as #Marlin and #Klipper.

So Creality released the sourcecode for the #SonicPad, be it with resistance, and after a while, because they had to because of #Klipper.

However. For the hotend of the CR6SE the used a load cell sensor, which could only communicate with #Marlin at that time if it wad emulated to bena different sensor, so they created an additional #PCB connected to the hotend that does this. Because this was their technology, it was colose source, and the cabling was also weird.

Then I think the #ArtilleryHornet had a USB-C cable for its hotendz, which seemed nice at the time, but it was a non-standard and closed source.

@RobeeShepherd

@3dprinting #3dprinting

Every time I see a new video popup on YouTube about the #Creality #SonicPad being the "easy way to #Klipper", I have to go there and add a disclaimer to the video comments to ensure people KEEP AWAY FROM THAT THING!!! 😠

Not only is that plainly FALSE, but they also broke the Open Source licenses of Klipper, Moonraker, Fluidd, Mainsail, KlipperScreen...

The Sonic Pad does NOT run Klipper, but an unsupported fork of Klipper, so be advised that you will NOT have official support for it!

Day 2, Electric Boogaloo. Auto-levelling problems galore.

https://www.anthonyfloyd.ca/2022/12/27/ender-3-s1-pro-day-2/

#3DPrinting #Ender3S1Pro #SonicPad

erster Test mit den schnellen Profileinstellungen im "normal mode".
Das ist nur 3x so schnell wie der alte Druckmodus.
#Creality #SonicPad