@amd

The #Sunlu is the most featured by far on Youtube, I believe #Modbot uses it as well. I don't personally have one, but I am eying the Sunlu.

The #Creality one is cheaper, but it has some stupid temperature restrictions, and people have had other problems with it. So I'll evade that one.

@3dprinting #3dprinting

Finally seems to be working. Once I fix the description I'll post a new #esp32 #speaker box on #printables.

Anyone have a use for freaking 4 whole spools of out-of-spec black #pla from #Sunlu?

#homeassistant #esphome #snarkhome #prusa

Another morning, another clogged PTFE teardown.

This #sunlu filament is cursed. Fat spots that the #Prusa pushes almost but not quite hard enough to feed without breaking.

So it breaks off right at the PTFE entry, stuck firmly enough that I need to remove the heatbreak and tube before I can get it out..

#3dprinting #pla

This morning's wizarding is a new case for my #esphome speakers. Specifically, I love https://www.printables.com/model/363300-esphome-speaker but it doesn't fit the ESP32 boards I settled on ( https://amzn.to/3JA0lpA )

If #esphome supported #i2s on #esp8266 this wouldn't be an issue. I have plenty of esp8266 boards that are roughly the right size. Alas, filing a bug would involve another fight with #stalebot.

Instead of climbing the #barriertoentry, I fired up #Fusion360 (thanks https://usebottles.com/app/#fusion360 !) and whipped up a quick alternate box bottom.

Unfortunately, some terrible no good very bad filament from #Sunlu has managed to completely jam my extruder right below the gear, so I can't print it yet.

I am so tired of rebuilding this stupid #Prusa. The hot-end was decent before the #mmu2 disaster, but that conversion and subsequent fix-after-fix has made it sketchy at best. At least I'm getting good at teardowns. (And I'm saving for the top MK4 upgrade to get rid of the PTFE entirely.)

This morning's wizarding is a new case for my #esphome speakers. Specifically, I love https://www.printables.com/model/363300-esphome-speaker but it doesn't fit the ESP32 boards I settled on. (If #esphome supported #i2s on #esp8266 this wouldn't be an issue. I have plenty of esp8266 boards that are roughly the right size.)

Fired up #Fusion360 via https://usebottles.com/app/#fusion360 and whipped up a quick alternate box bottom.

Unfortunately, some terrible no good very bad filament from #Sunlu has managed to completely jam my extruder right below the gear, so I can't print it.

I do not want to do another teardown of this stupid #Prusa today. I'm saving for the MK4 upgrade because this hot-end was OK before the #mmu2 disaster, but that conversion and subsequent fix-after-fix has made it sketchy at best. At least I'm getting good at rebuilding it.

RT @xyzfilaments: https://xyzfilaments.com/filamento-pla-seda-oro-claro-1kg-1-75mm-sunlu
💥Oferta PLA+ Seda Oro Sunlu 18,86€/kg💥

FIFA World Cup STL @cults3d

#xyzfilaments #sunlu #sunlufilament #silkfilament #3dmodel #3despaña #impresora3d #fifaworldcup #fifaworldcup2022 #3dportugal #cults3d #filamentos3d #artillery #artilleryx1

🐦🔗: https://nitter.net/Cults3D/status/1593549539666976769